Remote Controller; Outdoor Unit - Mitsubishi MR. SLIM MS-SD24VC Operating Instructions Manual

• OPERATING INSTRUCTIONS •
N
AME OF EACH PART
Indoor unit
Air cleaning fi lter
(Anti-Allergy Enzyme Filter)
Air fi lter
(Catechin air fi lter)
Air outlet
Vertical vane
Horizontal vane Display section

Outdoor unit

Appearance of the outdoor unit may differ from some models.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET
1.
Remove the front lid
3.
Install the front lid
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries. The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin stick.
If the RESET button is not pressed, the remote controller may not operate correctly.
En-3
Front panel
Air inlet
Emergency
operation
switch
Page 4
Operation indicator
lamp
Remote control
receiving section
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
2.
Insert AAA
alkaline batteries

Remote controller

Operation display
section
ON/OFF
(operate/stop)
button
FAN speed
control button
Page 5
Operation
select button
Page 4
ECONO
COOL
button
Page 6
VANE
control button
Page 5
LONG
button
Page 6
Use the remote controller provided with the unit only.
Do not use other remote controllers.
Setting current time
1.
Press CLOCK
3.
Press CLOCK again
• Press CLOCK gently using a thin stick.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Temperature buttons
Page 4
Off-timer button
Page 6
On-timer button
Page 6
WIDE VANE button
Page 5
TIME set buttons
Pages 3, 6
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
Remote controller
holder
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
2.
Press the TIME buttons to set the
time
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer)