Grouping Registration Of Indoor Units With M-Net Remote Controller - Mitsubishi City Multi PURY-P400 Service Handbook

4 GROUPING REGISTRATION OF INDOOR UNITS WITH M-NET REMOTE CONTROLLER

(1) Switch function
• The method used to register with a remote controller is shown below:
C Button to assign indoor
unit address
F Delete button
G Registered mode
selector button
E Confirmation switch
Symbol
Name
of button
A + B
Registration/ordinary
mode selection button
Button to assign indoor
unit address
Registration button
Confirmation button
Delete button
Registered mode
selector button
Button to assign
interlocked unit address
CENTRALLY CONTROLLED
D A I L Y
AUTO OFF
CHECK
STAND BY
DEFROST
TEMP
PAR-F27MEA
TIMER SET
Symbols
+
FILTER
C
of TEMP
D
TEST RUN
E
F
CLOCK → ON → OFF
G
H
of TIMER SET
1Hr
˚C
ON OFF
CLOCK
REMAINDER
CHECK MODE
TEST RUN
˚C LIMIT TEMP.
ERROR CODE NOT AVAILABLE
ON/OFF
ON OFF
CLOCK
H Button to assign inter-
locked unit address
This button is used to switch between ordinary mode and registered mode
(Ordinary mode is selected for the operation of indoor units)
* To select the registered mode, press and hold FILTER +
buttons for 2 seconds at stoppage.
[Note] The registered mode cannot be obtained for a while after power-
ing.
Pressing the FILTER +
TROLLED".
This button assigns the unit address to "INDOOR UNIT ADDRESS
NO."
This button is used for group/interlocked registration.
This button is used to retrieve/identify the content of groups, interlock
(connection information), and registration.
This button is used to delete the content of groups, interlock
(connection information), and registrtion.
This button selects indoor units to register as groups (group setting mode)
or interlocked (interlocked setting mode).
* The unit address is shown at one spot
while at two spots for the interlocked setting mode.
This button assigns the unit address of "OA UNIT ADDRESS NO."
–34–
FILTER
A
Registration/
ordinary mode
FILTER
selector button
CHECK TEST
D Registration button
B
Registration/
ordinary mode
selector button
Description
buttons displays "CENTRALLY CON-
for the group setting mode