Preparation; Remote Control Batteries Installation; Handling The Remote Control - Hitachi P50XR01E User Manual

PREPARATION

Remote Control Batteries Installation

This remote control operates on 2 "AA" batteries.
1. Open the battery compartment cover
Slide open the battery compartment
cover on the backside in the
direction of an arrow, and remove
the cover.
2. Install the batteries
Install 2 "AA" batteries (included)
making sure the polarities match
the indication inside the
compartment.
3. Close the battery
compartment cover
Make sure of the positions
to fi t the projecting parts in
the holes, and slide the
compartment cover in the
direction of an arrow till it
clicks shut.
CAUTION
It could cause corrosion or battery leakage and may result in physical injury
and/or property damage including fi re.
Never mix used and new batteries in the device.
Replace all the batteries in a device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible failure, read the following instructions and handle the
remote control properly.
Do not drop or cause impact to the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on a wet object.
Do not place the remote control under the direct sunlight or near sources of excessive heat.
16
Holes
Projecting
parts

Handling the Remote Control

Use the remote control within about 5m from
front of the unit's remote-control sensor and
within 30 degrees on both sides.
Within 30
degrees
About 3m
Within 30
degrees
About 3m
Within
about 5m