Preparation; Remote Control Batteries Installation; Handling The Remote Control; Caution When Moving The Main Unit - Hitachi P42H01U User Manual

PREPARATION

Remote Control Batteries Installation

This remote control operates on 2 "AA" batteries.
1. Open the battery compartment cover
Slide open the battery compartment cover on the
backside of the remote control in
the direction of an arrow.
2. Install the batteries
Install 2 "AA" batteries (included)
making sure the polarities match
the indication inside the
compartment.
3. Close the battery compartment cover.
To close the battery compartment
cover, slide the cover in the
direction of an arrow till it clicks
shut.
CAUTION
It could cause corrosion or battery leakage and may result in physical injury and/or
property damage including fire.
Never mix used and new batteries in the device.
Replace all the batteries in a device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible failure, read the following instructions and handle the remote control
properly.
Do not drop or cause impact to the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on a wet object.
Do not place the remote control under the direct sunlight or near sources of excessive heat.

Caution When Moving the Main Unit

As this product is heavy, whenever it is moved, two people are required to transport it safely.
Whenever the unit is moved,
it should be lifted forwards
using the two handgrips
at the back, and the unit
should then be held at the
base on both sides for
stability.
12
Handgrips

Handling the Remote Control

Use the remote control within about 5m from
front of the unit's remote-control sensor and
within 30 degrees on both sides.
Within 30 degrees
About 3m
Within 30
degrees
About 3m
About 5m