Appendix A: Mm-4 Weather Protected Cable Assembly Procedure - Meyer Sound MM-4CEU Operating Instructions Manual

APPENDIx A
mm-4 Weather Protected Cable Assembly Procedure
Cable
Step 1:
Feed the end of the cable through the boot, cable clamp housing,
and coupling ring in the order and position shown.
Cable
Step 2:
Strip cable as shown and solder conductors to pins.
NOTE: Pin 1 is negative (-) and pin 2 is positive (+)
Coupling Ring
Step 3:
Align coupling ring tabs with cord connector's side notches and push
the coupling ring onto cord connector.
Step 4:
Push the cable clamp housing foward until it locks into the connector body
and snap the two clamps into their compartments.
Step 5:
Push the boot all the way foward to seat tightly onto the cable clamp housing.
Boot
Cable Clamp Housing
Cord Connector
3/8" Max.
7/32"
Cord Connector
Tab
Tab
NOTE: The EN3 cable mount connector accepts conductors up to
16 AWG (1.5 mm ) and an outside jacket diameter of 0.265 inches
2
(6.73 mm).
Coupling Ring
Cord Connector
Contact Pins
Dot (pin 1
indicator)
1-
2+
Contact Pins
Side notch
Clamp
Clamp
Lock
Solder
2+
1-
9/32"
Cord Connector
APPENDIX A
13