McCulloch MC1275 Instructions Manual page 8

ATTACHING UTILITY BRUSHES
WARNING: Do not try to connect accessories while unit is emitting steam.
This section applies to all Utility Brushes. Note that Utility Brushes attach to Steam
Jet Nozzle, not to main steam nozzle.
1. Align guide tab on inside of Utility Brush (FIGURE 3-A) with groove on bottom
of Steam Jet Nozzle tip (FIGURE 3-B), and firmly press Utility Brush onto
Steam Jet Nozzle.
2. Press Utility Brush as far on to Steam Jet Nozzle as possible to ensure that it is
properly sealed, to help prevent any steam leakage (FIGURE 4).
3. To remove Utility Brush, simply grip it firmly and pull it off of Steam Jet
Nozzle.
ATTACHING SCRUB PAD
This section applies to the Scrub Pad. Note that Scrub Pad
attaches to Steam Jet Nozzle, not to main steam nozzle.
1. Place Scrub Pad over tip of Steam Jet Nozzle, and firmly
press it as far on to Steam Jet Nozzle as possible to ensure
that it is properly sealed (FIGURE 5). This will help
prevent any steam leakage.
2. To remove Scrub Pad, simply grip it firmly and pull it off of
Steam Jet Nozzle.
8
A
H -D
EAVY
FIGURE 3
Top Innovations, Inc.
SSEMBLING THE
S C
UTY TEAM LEANER
FIGURE 4
FIGURE 5