McCulloch MC1275 Instructions Manual page 12

PROBLEM
Unit fails to steam. Lighted
On/Off Switch does not
illuminate.
Unit fails to steam. Lighted
On/Off Switch does illuminate.
Steam output is intermittent.
Unit is emitting excess water.
12
T
ROUBLESHOOTING
POSSIBLE CAUSE
Unit is not plugged in.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Water Reservoir is empty.
Mineral build-up in unit.
Mineral build-up in unit.
Water condensation in Steam
Hose.
Water Reservoir has been
over-filled.
Unit has not reached operating
temperature.
Top Innovations, Inc.
SOLUTION
Plug into electrical outlet.
Reset Circuit Breaker / Ground
Fault Interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Refill Water Reservoir using
procedures on page 9 of this
manual.
Follow Removing Mineral
Build-Up procedure on page 11
of this manual.
It is normal for unit to
periodically stop steaming for a
few seconds. If steam stays off
for longer periods, follow
Removing Mineral Build-Up
procedure on page 11 of this
manual.
Point main steam nozzle towards
sink, tub or ground and shake
while depressing Steam Button.
Continue until excess water is
released.
Point main steam nozzle towards
sink, tub or ground and shake
while depressing Steam Button to
remove water that may have
condensed in Steam Hose.
Empty some water out of Water
Reservoir.
Wait until Steam Ready Light
deactivates to steam.