Stack Dryer Diagnostic Program - Maytag MDE/MDG21PDA Service Manual

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.

Stack Dryer Diagnostic Program

Dryer
Diagnostic
Program
34
!
Enter Operator
Mode by unlocking
the service switch
If any segments of display
are not flashing. Replace
the control board.
Is dryer drum
Yes
turning?
No
Refer to dryer
drum will not turn
section.
16022904 Rev. 0
WARNING
If a diagnostic
code is displayed
refer to
corresponding
section of trouble
shooting guide.
Dryers should be
near room
temperature,
plugged in, and
doors closed.
Is heater on? (Allow
ample time for gas
flames to ignite)
No
Refer to no heat
section.
To enter
diagnostic mode
or clear diagnostic
codes press a
delicates keypad
for at least 1
second. customer
cycles will be
terminated
To initiates a
service cycle push
the permanent
press keypad for
the dryer(s) to be
started-- upper or
lower.
Yes Dryer check ok.
If desired, push
the respective
delicates keypad
to cancel the
service cycle.
Exit operator mode
by locking the
service door.
©2004 Maytag Appliances Company