Windows Xp,2000, And Me Installation - M-Audio Delta 1010LT User Manual

3. Select the PCI slot where you will install your Delta 1010LT PCI host card.
Make sure the slot is a PCI slot. If you don't know what "PCI slot" means,
check the owner's manual for your computer. PCI slots are distinguishable
from ISA slots by being shorter and set back farther from the outside of the
computer, however some newer computers have only PCI slots.
4. Before removing the Delta 1010LT PCI host card from its protective anti-static bag,
touch the metal power supply case of the computer in order to dissipate any static
electricity your body may have accumulated. You might want to pick up a grounding
wrist strap (available from electronics stores like Radio Shack) if you want to be
doubly sure you aren't carrying a static charge that could damage the card.
5. Remove the metal bracket that covers the access hole on the back of the
computer. This bracket is usually fastened to the computer with a single screw.
6. Position the Delta 1010LT PCI host card over the target PCI slot and fit the card
loosely over it with the card in the upright position. Press the card gently but
firmly downward into the slot until the card is completely and squarely seated
in the slot. If the card seems difficult to seat, a slight rocking motion may help.
7. Screw the Delta 1010LT PCI host card's metal bracket down into the screw hole
on the back of your computer using the screw you removed in step 5 above.
8. Place the cover back on your computer.
IMPORTANT: Complete the attachment of your Delta 1010LT
breakout cables to the PCI card before powering up your computer.
Never attach a breakout cable to the PCI card while the computer
is on. Doing so could damage the PCI card and void the warranty.
With your computer turned off, it is now time to connect the Delta 1010LT breakout
cables to the PCI host card that you have just installed. You may at this time also want to
connect to audio gear that you using in conjunction with your Delta 1010LT.
Delta Driver Software Installation - for PC
The Delta 1010LT system includes a driver CD for Windows XP/2000/ME/98/95/NT (and
Macintosh, too), containing all Windows drivers and Delta Control Panel software. To install
these on your system, please follow these steps:

Windows XP,2000, and ME Installation

1. After installing the Delta 1010LT hardware, boot your system and start
Windows. During the Windows boot procedure, new hardware will be
automatically detected by the Add New Hardware Wizard announcing "New
Hardware Found." Click 'Next>'.
2. The 'Add New Hardware Wizard' will now ask how you want to find the
driver. "Search for the best driver for your device" is already selected. Click
'Next>'.
3. Windows will give you a selection of locations to search. Make sure that only
"Choose a Path" is checked, or click on the check box to do so. Insert the Driver
CD into your CD ROM drive. Type in the drive letter of your CD drive (we will
assume here that it is D:\) and the path to the Delta drivers, which will be
D:\Delta Series\Wdm. Click 'Next>'.
9