Troubleshooting Tips For Frequently Asked Questions - M-Audio Delta 1010LT User Manual

To change your system to Standard PC mode:
1. Boot into Windows and open the Device Manager. Right-click the + sign next to
"Computer."
2. Double-click the entry that appears under Computer, which should indicate that the
computer is in ACPI mode. Click the Driver tab, then click the "Update Driver" button.
3. The Upgrade Device Driver Wizard will appear. Click Next>. Select "Display a list of
known drivers for this device..."and click Next>.
4. Select the radio button "Show all hardware of this device class." In the list on the right,
select "Standard PC,"then click Next>. Follow the prompts, and restart your computer
when instructed.

Troubleshooting Tips for Frequently Asked Questions

Problem: No Sound.
Possible Cause 1: The Delta 1010LT hardware or software device drivers
are not properly installed. See the installation sections of this manual for further
information.
Possible Cause 2: There is a resource conflict between the Delta 1010LT and
another device in your computer. Check the Delta 1010LT configuration (Address, IRQ)
against those of the other installed devices. If necessary, change the settings for the one or
more of the devices.
Possible Cause 3: Your application software has not been properly configured to
use the Delta 1010LT as its audio output device.
Possible Cause 4: Misrouted outputs in the Delta Control Panel. Check the Delta
Control Panel's Patchbay/Router page to verify output routing assignments. Also, make
sure that if the output is routed from the digital mixer, that the mixer's faders, solo and
mute controls are set up properly.
Possible Cause 5: Improper connections of the audio accessories. Verify that the
Delta 1010LT analog audio outputs are properly connected to a digital mix deck or
external mixer/amplifier, or the S/PDIF Out is connected to an external digital audio
device capable of receiving S/PDIF.
Problem: No visual activity on Audio Input volume (VU) meters of user software.
Possible Cause 1: The Delta 1010LT input devices are not properly selected in
the user's application software.
Possible Cause 2: If the software is recording from the Delta 1010LT's monitor
mixer device, be sure that the mixer's faders, solo and mute controls are set up properly.
Possible Cause 3: Improper connections to audio accessories.
52