Displayed Information (For Troubleshooting) - Fujitsu ECLIPSE CD8445 Owner's Manual

Displayed information (for troubleshooting)

The information listed in the chart below is displayed to show the status of
the CD, Memory Stick player, Area Shot function, Sirius Radio and CD
changer. Refer to the chart for the appropriate action.
Information Contents
INFO 2
INFO 3
INFO 5
INFO 6
INFO 7
LOAD
MSINFO 1
MSINFO 2
MSINFO 3
MSINFO 4
NO DISC LOADED IN
THE MAGAZINE
DISCS ARE DIRTY OR
DAMAGED
CD PLAYER AND CD
CHANGER FAILS
MECHANICALLY
WHEN THE CD PLAYER
AND CD CHANGER
INTERNAL
TEMPERATURE IS HIGH
(TO PROTECT PICKUP
UNIT)
AN INTERNAL POWER
SUPPLY FAILURE IS
OCCURRING
YOU TRIED TO
PLAYBACK,
RECORDING AND
READING DATA WHEN
NO MG MEMORY
STICK OR MEMORY
STICK WAS INSERTED
YOU TRIED TO
PLAYBACK AN
INCORRECTLY
FORMATTED MEMORY
STICK
THE WRITE
PROTECTION SWITCH
IS LOCKED.
THE MEMORY STICK
FULL
Explanation and remedial action to take
There is no disc in the magazine or player.
Load a disc in the magazine. (Load a
music disc.)
The loaded disc is dirty or upside down.
Check it for proper orientation and verify it
is clean.
• The CD player and CD changer is
inoperative for some reason. Go through
the magazine removal procedure.
• If a magazine fails to eject, have your
dealer fix problem.
• The temperature in the CD player and
CD changer is too high for operation.
Wait till it cools down.
• Resume playing after the "High
temperature sensed and CD stopped"
display disappears. If the CD still cannot
play, have your dealer repair it.
• Turn the ACC off once before turning it
on once again to resume the operation.
• If this condition persists, please contact
your dealer.
CD changer is in the process of verifying
the presence of CDs after a magazine has
been inserted into the CD changer.
Insert MG Memory Stick or Memory Stick.
Use the deck to format the Memory Stick.
Unlock the write protection switch.
Delete some of the data from the Memory
Stick before saving.
191
If you have a question:
XVI