Epson Stylus C 60 Service Manual page 77

EPSON Stylus C60
Occurrence
timing Detailed phenomenon
CR position
The printing operation is correctly
performed. But, the top margin is
insufficient than usual one.
Printing is blurred.
Operation
-
A paper stains with ink
A top of a paper get wrinkled.
Troubleshooting
Table 3-19. Check point for the poor printing quality
Defective
unit/part name
1. Check if the any paper dust is adhered to the surface of the
LD roller.
LD roller unit
1. Check if the suitable paper is used according to the printer
Printer driver &
driver setting.
exclusive paper
1. Check if the correct Head ID is stored into the EEPROM
Printhead
by using the Adjustment program.
1. Check if the Front frame has the ink stain somewhere.
Front frame
1. Check if the Front frame is bent up.
1. Check if the Lower housing has the ink stain somewhere.
Lower housing
1. Check if the Paper eject roller has ink stain somewhere.
Paper eject roller
unit
1. Check if the Spur gear 60 comes off.
1. Check if the Paper guide upper/left has ink stain
Paper guide upper/
somewhere.
left
1. Check if the PF roller has ink stain somewhere.
PF roller
1. Check if the wiping operation is correct performed.
Printhead
2. Check if the Printhead cover has the ink drop.
1. Check if the Hopper pad is correctly pasted on the dent of
the Hopper.
ASF unit
2. Check if the LD pad is correctly pasted on the dent of the
Paper return plate.
Unit Level Troubleshooting
Check point
1. Set a cleaning sheet in the ASF up side down.
LD roller
1. Use the suitable paper according to the printer
1. Input 11 digits code of the Head ID into the
1. Clean the ink stain of the Front frame
1. Replace the Front frame with new one.
1. Clean the ink stain of the Lower housing
1. Clean the ink stain of the Paper eject roller
1. Replace the Printer mechanism with new one.
1. Clean the ink stain of the Paper guide upper
1. Clean the ink stain of the PF roller carefully
1. Replace the Printer mechanism with new one.
2. Clean the ink drop on the Printhead cover
1. Replace the he Hopper pad with new one.
2. Replace the LD pad with new one.
Revision A
Remedy
Then holding the top edge, try to load the
paper from the Printer driver. The micro
pearl on the LD roller surface is removed. To
remove severe smear, staple a cloth
moistened with alcohol to a post card and
clean the roller in the same manner.
As for the cleaning sheet, refer to page 59
"Remedy of the Paper out error"
*If the problem is not solved, replace the
Holder shaft unit with new one.
driver setting.
EEPROM by using the Adjustment program.
carefully with the soft cloth.
carefully with the soft cloth.
carefully with the soft cloth.
/left carefully with the soft cloth.
with the soft cloth.
carefully with the soft cloth.
72