Epson Stylus C 60 Service Manual page 107

EPSON Stylus C60
11. Lift the right side of the Printer mechanism carefully while releasing one hook for
securing the Printer mechanism to the Lower housing from the backside of the
Printer by using the tweezers.
Step1) Push
Figure 4-51. Printer mechanism removal (2)
12. Remove the Printer mechanism by lifting it at the points shown below (In this
time, the Paper eject roller is also removed with the Printer mechanism).
Figure 4-52. Printer mechanism removal
When lifting the Printer mechanism from the Lower housing, be
careful not to drip off the ink from the end (Waste drain ink pad
side) of the ink tube.
Do not remove the Printer mechanism upward by lifting it at the
unspecified position to avoid the deformation of the Main frame.
Disassembly and Assembly
Backside
Step2) Lift up
Hooks
When assembling the Printer mechanism to the Lower housing,
Make sure to set the Main frame reinforcing plate correctly
at the rightmost screw.
Figure 4-53. Reinforcing plate setting position
Avoid to damage the coated surface of the PF roller by using
the OHP sheet as shown figure below.
Figure 4-54. Printer mechanism assembling(1)
Disassembly
Revision A
Reinforcing plate
OHP sheet
101