Epson Stylus C 60 Service Manual page 65

EPSON Stylus C60
LED indication
Error condition
STM3 message
Power : On
Error : On
Paper out error
Paper not loaded
correctly
Occurrence
timing Detailed phenomenon
CR position
The Hopper does not operate during the
Operation paper loading sequence although the LD
- roller rotates to load a paper from ASF
unit.
Troubleshooting
Table 3-8. Paper out error condition and possible cause
Occurrence CR position at the
timing power on timing
Operation -
Table 3-9. Check point for the paper out error according to each phenomenon
Defective
unit/part name
1. Check if the Hopper operates correctly in the paper
ASF unit
Unit Level Troubleshooting
Unit/Part name
The Compression spring 2.50 comes off.
ASF unit
The Tension spring 29.1 comes off.
The Tension spring 0.143 comes off.
The Dowel in Clutch comes off.
The Clutch tooth is damaged.
Holder shaft unit
The Clutch is damaged.
The friction of the LD roller is lowered.
The Paper return plate disturbs the rotation of the LD roller.
Paper guide upper/left The Paper guide upper (only HP side) comes off.
The PF motor connector cable comes off.
PF motor The PF motor is defective.
The PF motor connector cable is damaged.
The Compression spring 1.764 comes off.
Pump unit
The tip of the Change lever is damaged.
Check point
loading sequence.
Possible cause
Refer to Table 3-9
Remedy
1. Reassemble the Compression spring 2.50
between the ASF frame and the Hopper.
Comp. Spring 2.50
Revision A
Check table
60