Pf Motor Removal - Epson STYLUS COLOR 480 Service Manual

EPSON Stylus COLOR 480

4.2.6 PF motor removal

1. Remove the Housing from the printer. (Section 4.2.1 Housing removal)
2. Remove the Waste drain ink pad unit from the printer. (Section 4.2.5 Waste drain ink
pad unit removal)
3. Remove two screws (C.B.S. 3x6,F/Zn screw) securing the PF motor to the Ink system
frame.
CR motor
Figure 4-20. Removing two screws securing the PF motor
4. Disconnect the connector cable for PF motor from CN3 on the Main board and take the
cable off from the hook on the Waste drain ink pad.
5. Remove the PF motor from the right frame.
Be sure that the PF motor cable is placed to the backward. Refer to
the Figure 4-20.
Disassembly and Assembly
C.B.S 3x6 F/Zn screws
Disassembly
n
Since the CN 3 is not located near the rear edge of the Main
board, it is easier to use the tweezers or pincers to connect the
cable to the CN3.
n
Tightening torque for screw
• C.B.S. 3x6 F/Zn screw for PF motor
Revision B
: 9+/1 kgf.cm
81