Power Cords; Power-Up Sequence - Gerber HS15 Plus User Manual

The plotter has a 25DB female connector with these pin assignments:
All other pins are not connected.

Power Cords

1. Insert the female connector of the HS15
the socket on the rear panel of the plotter.
2. Connect the power cords for both the
system and the HS15
plugged into a standard, grounded electrical outlet (115V +/- 10%
AC, 60 Hz or 230V AC, 50 Hz).
3. Turn power on at the system and the plotter.
CAUTION: When power is on, never try to manually move the
carriage, move the plotter drum, rotate the tool, or force the tool
up or down. Attempting to manually move the HS15
axis of movement while the power is on may damage the
machine.

Power-up Sequence

When the HS15
1. The light labeled
lights over
then off.
Pin Signal
2 Tx
3 Rx
4 RTS
5 CTS
7 Sig Gnd
plus
to a multiple outlet strip. The strip should be
plus
is turned on, the following sequence occurs:
comes on. A short beep sounds, and the
POWER
,
RUN CONT RUN SINGLE
Installation
plus
plotter power cord into
GRAPHIX ADVANTAGE
plus
in any
, and blink on,
SWIVEL KNIFE
9