Controlled Stop; Continuous Plot Exercise - Gerber HS15 Plus User Manual

plus
36 HS15

Controlled Stop

Use
RUN CONT
current job.
To stop a continuous mode plot
1. Press either Run key. The HS15
break in the program.
Note: The slew keys may be pressed to maneuver the carriage or
material. However, when the Run key is pressed again to exit the
pause mode, the plotter will return the carriage and material to the
point where the job was paused.
2. Press either Run key to resume plotting at the exact same point.

Continuous Plot Exercise

1. Turn on the HS15
set the tool force to .5.
2. Using the slew keys, position the carriage spindle approximately 1"
from the front edge of the plotting paper. Also, be sure that there are
several inches of paper extending past the carriage spindle and to the
left of the plotter.
3. Prepare two plot files. In the Plot Program, choose a left Start
Position and a right End Position for both plots before sending them
to the plotter.
Note: If both plot files have a left Start and left End Position they
may plot on top of each other.
Note: Entering an X,Y pre-position in the Plot Program is another
way to be sure that plots done in the
on top of each other. (See
4. Press the
between them.
(or ) to stop plotting and check the
RUN SINGLE
plus
plus
. Load plotting paper, install the pen holder, and
GRAPHIX ADVANTAGE
key. Both jobs will plot without going off-line
RUN CONT
stops the plot at the next logical
mode will not plot
RUN CONT
Reference.)