Gerber HS15 Plus User Manual page 75

KEY/FUNCTION
RUN SINGLE Key --
Plot
Controlled Stop
RUN CONT Key --
Plot
Controlled Stop
Slew Keys --
Arrow Keys
SLOW Key
RESET Key --
Emergency Stop
Clear
Access
plus
HS15 REFERENCE CARD
Press to plot single jobs. The HS15
RUN SINGLE
power-up) after each job and waits for the operator to press
plot the next job.
Press either Run key to pause plotting at the next logical break in the program and
check current job. Slewing while in pause will result in the plotter returning to the
position in the job and resuming the job when
Press to plot two or more jobs continuously. The HS15
RUN CONT
after the other without pausing between them and remains on-line until the
key is pressed again or
CONT
Press either Run key to pause plotting at the next logical break in the program and
check current job. Slewing while in pause will result in the plotter returning to the
position in the job and resuming the job when
The arrow and keys do not function while a job is plotting, during an error
SLOW
condition, or while a Run light is on, even if the plotter is idle.
Press arrow keys to position carriage and material between jobs.
• Up and down arrow keys move the carriage between the rear and the front of the
plotter.
• Left and right arrow keys rotate the drum and feed material through the plotter or
back toward the roll holder.
Press the key (a single beep indicates slow slew mode) and press the arrow
SLOW
keys to slow slew. Press the
and hold down a right or left arrow key to ramp up to high speed slew.
Press key to stop HS15
RESET
return the plotter to off-line status.
Press the key to stop the error signal after a power-up or plotting failure. (See
RESET
"Error Conditions" section in this manual.)
Hold the key at power-up to access additional diagnostics. (See "Special
RESET
Diagnostics" section in this manual.)
DESCRIPTION
plus
returns to the off-line status (as at
RUN SINGLE
is pressed.
RESET
RUN CONT
key again (two beeps indicate normal slew mode)
SLOW
plus
operation, clear the current job from the buffer, and
key again to
RUN SINGLE
is pressed again.
plus
plots one job
RUN
is pressed again.