10. Tension release
40
1
Simultaneously with the beginn of the thread cutting procedure the
thread release slide 1 opens the upper and lower thread tension .
The thread release slide 1, in the idle position of the thread cutting
device, should lie approx. 0.5 mm in front of the tension discs.
Caution Risk of Injury !
Turn off main switch before adjusting.
–
Set the thread cutting device according to chapter 8.1.
–
Loosen screw 2.
–
Slide the tension bar so that there is a clearance between the
claws and the tension release of 0.5 mm.
–
Tighten screw 2.
2