Lubrication - Duerkopp Adler 506 Operating Instructions Manual

4.2 Lubrication

For lubrication of the machine use only ESSO SP-NK 10 lubricating oil.
SP-NK 10 is available from DÜRKOPP ADLER AG sales offices.
Check the oil level in the oil reservoir of the oil mister
The run of the barrel shuttle is lubricated and cooled by compressed
air enhanced with oil from the oil mister.
–
The oil level in the oil reservoir 5 may not fall below the groove
marking.
–
If necessary top up the oil to the groove marking.
–
For this shut off the compressed air completely by turning the
knob 1 to the left.
–
For topping up screw out the oil filler screw 4.
–
After topping up set the operating pressure at 6 bar by pulling up
the knob 1 and turning to the right.
The set operating pressure can be seen on the pressure gauge 2.
1
2
Check the feed quantity of the oil mister weekly
–
Under operating pressure a drop of oil should drip out of the pipe
under the viewing glass 5 after every 2 to 3 work cycles.
–
Regulate the strength of the thus created oil mist at the setting
screw 3.
3
4
5
17