Duerkopp Adler 506 Operating Instructions Manual page 6

8
–
For a secure sewing-on draw the thread end hanging out of the
needle taut to the side when starting the first sewing sequence
and hold tight.
After the first stitches the thread can be released again.
–
The automatic sewing sequence runs through according to the
selected sewing program (P01 - P03).
For an exact description of the different sewing programs see Part
4 "Short Description Multicontrol".
–
After the sewing sequence ends the clamps are raised
automatically.
–
Remove the sewing material.
Quick stop
The safety system of the 506 has two different options for the
immediate shut-off of the unit by operator error, needle breakage,
thread breakage etc.:
–
Pressing the Stop key 1 on the front panel of the controls.
The sewing sequence is interrupted.
The thread lever moves to the high position.
–
Pressing the Stop key 2 on the head cover.
The sewing sequence is interrupted.
The thread lever moves to the high position.
To continue the sewing sequence:
–
Operate the left foot switch.
1
2