Programming From The Keypad - Linear ACCESS AE-100 Guide Facility Manager’s Manual

Access to Programming
To make it easy for installers familiar with Linear's and other manufacturer's
access control systems, two methods of programming are available.
Programming Position Numbers (or Function Codes) that match other
equipment help the installer to make quick programming changes with
keystrokes they've used before.
Automatic Programming Method Selection
The Programming Position Numbers (or Function Codes) change
depending on the programming method used. Refer to the table on
Page 13 for the numbers used for each programming method.
The keys used to enter programming from the unit's keypad select
which programming method is used for the current programming
session.
Entering programming by pressing
Standard Programming Method (Linear Access style). Details of each
programming step when using the Standard Programming Method
are shown on Pages 7-13.
Entering programming by pressing
the Alternate Programming Method (other manufacturer's style). Details
of each programming step when using the Alternate Programming
Method are shown on Pages 15-21.
Programming from the Keypad (Standard Method)
The system can be programmed using the keypad on the faceplate of the
AE-100. The display will show the programming information.
Accessing Programming from the Keypad
1. Press & keys at the same time, then release.
2. The display will show [PASSWORD:].
3. Enter the Master Password (factory setting is 123456).
4. Press:
5. If the password is correct, the display will
show [ENTER FUNCTION:].
6. Programming commands can now be entered on
the keypad. Refer to the following sections of this
manual for programming step details. Also refer to the
fi gure for alphanumeric entry using the keypad.
Keypad Audio Prompts
When programming using the keypad, each programming step consists of
entering programming data. With the Standard Programming Method,
the system will sound beeps to indicate correct or incorrect entries.
•
After a correct entry, two short beeps will sound.
•
After an incorrect entry, one long beep will sound.
•
After the complete programming step has been entered correctly,
three short beeps will sound.
Re-entering a Command After a Mistake
If an incorrect entry, or an incorrect key is pressed during programming, to
clear the keypad press and start the programming step over again.
Exiting Programming Mode
1. Press:
✦ NOTE: The AE-100 will automatically exit Programming Mode after
two minutes of programming inactivity.
4
& keys together will select the
& keys together will select
PRESS
PRESS
KEYPAD ALPHANUMERIC ENTRY
(FOR PROGRAMMING STEPS REQUIRING TEXT)
a b c
m n o
j k l
v w x
s t u
backspace
or erase
entire line
space, minus sign, dot
• 1ST PRESS IS 1ST LETTER
• 2ND PRESS IS 2ND LETTER
• 3RD PRESS IS 3RD LETTER
• 4TH PRESS IS THE KEY NUMBER
• 5TH PRESS IS 1ST LETTER AGAIN
• WAIT 3 SECONDS FOR THE NEXT CHARACTER (A BEEP WILL SOUND
AFTER THE 3 SECOND DELAY TIME) OR PRESS ANOTHER KEY
• THE FIRST LETTER OF EACH WORD WILL BE UPPER CASE,
TO MAKE AN ENTIRE WORD UPPER CASE TEXT, ENTER # FIRST
• FINISH ENTRY BY ENTERING #
• PRESS STAR KEY TO BACKSPACE, PRESS STAR AGAIN TO ERASE LINE
AND TOGETHER
FOR
STANDARD PROGRAMMING METHOD
AND TOGETHER
FOR
ALTERNATE PROGRAMMING METHOD
d e f g h i
p q r
y z ,
finish
entry