Table of Contents
Advertisement
brief display of the digit '1', then
F3f
F3
f
will be a brief display of the digit '9'. You can reset all of the configured
options back to the factory default states by typing
F5f
F5
f
F6f
F6
and
mouse connections.
F1 - Display firmware first digit (Note: F1 is
F2 - Display firmware second digit
F3 - Display firmware third digit
F5 - Restore PS/2 mouse function to the currently selected CPU's mouse port
F6 - Restore IntelliMouse function to the currently selected CPU's mouse port
F8 - Reset all configurations to factory default settings. An 'r' will show briefly on the
display to confirm that the reset has been completed.
4.7 Setting a security password
There are many situations where unrestricted access to corporate file servers or
sensitive information needs to be controlled. In such circumstances, the CPU Switch
Smart SUN-MAC-PC can be locked away in a room or secure cabinet and controlled
remotely. In this mode typing the keyboard hotkeys together with 'L' will blank the
screen, disconnect the keyboard and mouse from all of the computers and display
'P' on the CPU Switch Smart SUN-MAC-PC display. Control can only be regained by
typing the correct password on the keyboard.
To set the password in configure mode, first type 'P' then (return). The display on
CPU Switch Smart SUN-MAC-PC will change to show '=' and you can then type
your password. The password is not case sensitive and can be any combination of
key strokes, including the function keys, but excluding the (ctrl), (alt), (shift) and
(return) keys and the keys that only appear on a Sun type keyboard (i.e. Help, Stop,
Again, props, Undo, Front, Copy, Open, Paste, Find, Cut and the media control
keys). When you have typed in your password type (return) to register it in the
stored memory. Do not worry if you type the password incorrectly, you can always
re-enter configure mode and set the password again. If you have lost the password
and the CPU Switch Smart SUN-MAC-PC is locked, the unit may be unlocked by
powering down the CPU Switch Smart SUN-MAC-PC, entering configure mode at
power on (see section 2.6), and performing a complete reset using the F8 function.
NOTE - The password consists of a combination of key strokes rather like the code
CPU Switch Smart SUN-MAC-PCInstallation and Use
F2f
F2
f
f
to restore mouse function on disconnected PS/2 CPU
will be a brief display of the digit '2', then
F8f
F8
f
F
F
1
1
followed by
. Use options
l
l
NOT
)
Page 36
Advertisement
Table of Contents
