4.2.5.3 Cartridge Base Removal
Removal of the cartridge base is useful when removing the head cables, the head fan motor, and the
paper width sensor.
When removing the cartridge base, be careful not to snap the tabs.
Step 1: Remove the printer mechanism. (Refer to Section 4.2.5.1.)
Step 2: Remove the printhead. (Refer to Section 4.2.1.)
Step 3: Remove the screw CB(M4X8) securing the cartridge base to the carriage.
Step 4: Release the three tabs at the back of the cartridge base, then remove the cartridge base by
lifting it straight up.
I
W A R N I N G
Tab
Figure 4-26. Cartridge Base Removal (1)
Figure 4-27. Cartridge Base Removal (2)
4-17
' T w e e z e r s
REV.-A