Line Feed Speeds - Epson LQ-2550 Technical Manual

Feeding Method
NOTES: 1. When using friction feed:
Select friction feed on the control panel.
Do not use continuous (fanfold) paper.
Do not use a single sheet paper shorter than 92mm or longer than 364mm
Do not perform any reverse paper feed operations within the top 8.5 mm and bottom
22 mm of the paper.
Do not perform reverse feed beyond 1/6" after the paper end has been detected.
Do not use multi-part, single-sheet forms.
2. When using push-pull tractor feed:
Select tractor feed on the control panel.
Mount the pull tractor unit (optional).
Do not loosen the paper between the platen and the pull sprocket.
Precisely align the horizontal position of the pull sprocket and push tractor.
Do not perform reverse feeding for more than 1/6".
Do not perform reverse feeding after the paper end has been detected.
Multiple copy paper must be pasted together using line or dots.
Copy paper must be carbonless multi-part paper.
Paper Loading Directions
Fanfold paper
Cut sheet paper
Line Spacing
Line Feed Speed
Feeding Method
Friction without CSF
Friction with CSF
Tractor
Friction feed
Tractor feed (push: standard, push-pull: optional)
Inserted from the rear
Inserted from the top
1/6", 1/8", or programmable in units of 1/1 80" orl/360"
See Table 1-3.
Table 1-3. Line Feed Speeds
1/6" line spacing
[ins/line]
84
1-4
Continuous
[inch/s]
4.0