Jumper Setting; Selectype Function; Table 1-12. Font Selection; Table 1-13. Character Pitch Selection - Epson L-1000 Technical Manual

REV.-A

1.4.2 Jumper Setting

Jumper 6, which is user-selectable, is located inside the ROM cartridge slot cover. If the jumper is connected,
the signal is fixed to LOW, and DC1 /DC3 printer select control is ignored.
SLCT-IN

1.5 SELECTYPE FUNCTION

Selectype allows the user to choose fonts easily while the printer is ON-LINE. This function provides for selec-
tion of Draft, Roman, Sans Serif, or the slot (ROM cartridge) font. SelecType is effective only when the printer
is ON-LINE and is not printing. Font selection is performed by pressing the FORM-FEED switch with the printer
and not printing. The printer's control panel indicates which font has been specified.
ON-LINE
LQ-500/ L-1000

Table 1-12. Font Selection

1-4 1-5 Font
Off Off Roman
On Off Sans Serif
Slot
Off On
On On Draft

Table 1-13. Character Pitch Selection

Character Pitch
2-7 2-8
Off Off 10 CPI
On CPI
Off 12
Off On 15 CPI
On On Proportional
GENERAL DESCRIPTION
1-15