Table of Contents
Advertisement
CAB LE C ONN ECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX connector configuration
INPUT
CAUTION
3-PIN TO 5- PIN CON VE
Note!
3 P
IN TO
Con
duc
Ground/Shield
Data ( - ) signal
Data ( + ) signal
Do not use
Do not use
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector sid
the DMX cable to the output (female) 3
connector of the controller.
2.
Connect the end of the cable coming from
the controller which will have
pin connector to the input connector of the
next fixture consisting of a (male) 3 pin
connector.
3.
Then, proceed to connect from the outpu
as stated ab
fixture and so on.
CHAUVET Certified DMX Data Cables
Order Code
DMX1.5
DMX4.5
DMX10
MiNWash
COMMON
1
DMX +
3
2
-
DMX
Do not allow contact between the common and the fixture's chassis ground. Grounding the common
can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm meter to
verify correct polarity and to make sure the pins are not grounded or shorted to the shield or each othe
R SION CHAR T
If you use a controller with a 5
CHAUVET Model No: DMX5M, or DMX5F.
The chart below details a proper cable conversion:
5 P
C
C
IN
ONVERSION
HART
3 Pin Female (output)
tor
Pin 1
Pin 2
Pin 3
a (female) 3
ove to the input of the following
D
escription
DMX Cable 1.5m/4.9ft
DMX Cable 4
.5m/14.8ft
DMX Cable 10m/32.8ft
1
3
2
1
OUTPUT
3
Termination reduces signal errors. To
2
avoid signal transmission problems
and interference, it is always
advisable to connect a DMX signal
terminator.
pin DMX output connector, you will need to use a 5 pin to 3 pin adapter.
5 Pin Male (Input)
Pin 1
Pin 2
Pin 3
Do not use
Do not use
U
niversal DM
X Controller
e of
pin
t
Continue the link
8
Resistance 120
ohm 1/4w between
pin 2 (DMX -) and
pin 3 (DMX +) of
the last fixture.
r.
This drawing provides a
general illustration of the
DMX Input/Output panel of
a lighting fixture.
2007-09-14/09:44
Advertisement
Table of Contents
