Assembling The Sewing Machine Head; Integrating The Sewing Machine Head Into The Stand; Assembling The Protective Belt Cover On The Sewing Machine Head - DURKOPP ADLER 838 Instruction Manual

4.

Assembling the sewing machine head

4.1

Integrating the sewing machine head into the stand

4.2

Assembling the protective belt cover on the sewing machine head

–
If the special sewing machine is equipped with a drive (direct drive)
on the machine head, then you should insert the head section (1)
diagonally into the space on the table plate.
–
Be sure to screw in the installation plate (2) immediately after
inserting the head section. This will prevent the head section from
falling out if tilted or turned over.
The installation plate is included in the machine head's accessory
pack.
1
3
4
–
Take off the handwheel (1).
–
Mount the Hall sensor (2) to the machine head. This part is
included in the "motor part set".
–
Mount the protective belt covers (3) and (4). (These are included in
the "motor part set".)
–
Mount the handwheel (1). Be sure to maintain the proper angled
position: when the needle position is "high", the handwheel
pointer "0" should be aligned with the mark on the machine head.
1
2
GB
2
7