Lenovo ThinkCentre M90 Hardware Maintenance Manual page 63

Hardware maintenance manual
Hide thumbs Also See for ThinkCentre M90:
Table of Contents

Advertisement

Diagnostic Error Code
030-027-XXX SCSI interface Configuration/Setup error
030-03X-XXX 030-04X-XXX SCSI interface error
030-195-XXX SCSI interface Test aborted by user
030-196-XXX SCSI interface test halt, error threshold
exceeded
030-197-XXX SCSI interface test warning
030-198-XXX SCSI interface test aborted
030-199-XXX SCSI interface test failed, cause unknown
035-000-XXX RAID interface Test Passed
035-0XX-XXX RAID interface Failure
035-195-XXX RAID interface Test aborted by user
035-196-XXX RAID interface test halt, error threshold
exceeded
035-197-XXX RAID interface test warning
FRU/Action
1. SCSI signal cable
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 392
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Check AC/DC power adapter
3. SCSI device
4. SCSI adapter card, if installed
5. System board
Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See "" on page .
2. Re-run the test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
1. If a component is called out, make sure it is
connected and/or enabled. See "" on page .
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 392.
3. Go to "Undetermined problems" on page 64.
1. Go to "Undetermined problems" on page 64.
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 392.
3. Replace component under function test.
No action
1. RAID signal cable
2. RAID device
3. RAID adapter card, if installed
4. System board
Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See "" on page .
2. Re-run the test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
Chapter 7
.
Symptom-to-FRU index
55

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents