Lenovo ThinkCentre M90 Hardware Maintenance Manual page 58

Diagnostic Error Code
001-301-XXX System RTC Century byte error
005-000-XXX Video Test Passed
005-00X-XXX Video error
005-010-XXX 005-011-XXX 005-012-XXX 005-013-XXX
Video Signal failure
005-016-XXX Video Simple Pattern test failure
005-024-XXX Video Addressing test failure
005-025-XXX Video Checksum Value error
005-027-XXX Video Configuration/Setup error
005-031-XXX Video Device Cable failure
005-032-XXX Video Device Controller failure
005-036-XXX Video Register error
005-038-XXX System BIOS extension failure
005-040-XXX Video IRQ failure
005-195-XXX Video Test aborted by user
005-196-XXX Video test halt, error threshold exceeded
005-197-XXX Video test warning
50
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 392.
2. System board
No action
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video Ram
2. Video card, if installed
3. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Run the Setup Utility program.
2. Video drivers update
3. Video card, if installed
4. System board
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
Information only Restart the test, if necessary.
1. Press F3 to review the log file.
2. Restart the test to reset the log file.
1. Make sure the component that is called out is
connected and/or enabled. See "" on page .
2. Re-run the test.
3. Replace the component called out in warning
statement.
4. Replace the component under test.