Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZDTS401
Summary of Contents for Zanussi ZDTS401
- Page 1 User manual Dishwasher ZDTS401...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Multitab function _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Select and start a washing programme _ _ _ _ _ 13 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5... -
Page 3: Control Panel
• A qualified and competent person must do the elec- – if the control panel, worktop or plinth area are trical installation. damaged, that you can get access to the inner side of the appliance. • A qualified and competent person must do the Contact your local Service Force Centre. -
Page 4: Delay Start Button
Indicator lights The indicator light comes on when it is necessary to fill the rinse aid. Refer to the chapter 'Use of rinse aid'. 1) The indicator light is off while a washing programme operates. Delay start button 2. Make sure that the appliance is in setting mode. 3. -
Page 5: Washing Programmes
cancel the programme to go back to the setting mode. Optical signal Refer to the chapter "Setting and starting a washing The red Indication of a malfunction. programme". light flash- Optical signal After the start of the washing programme, an optical The red Indication of the end of a washing pro- signal shows on the floor below the appliance door. -
Page 6: Consumption Values
Programme Degree of soil Type of load Programme description Normal or light soil Crockery and cutlery Main wash up to 65°C Final rinse Normal soil Crockery and cutlery Prewash Main wash up to 50°C 1 intermediate rinse Final rinse Drying Light soil Crockery and cutlery Main wash up to 50°C... -
Page 7: Use Of The Appliance
Programme Duration (in minutes) Energy (in kWh) Water (in litres) 160-170 0,8-0,9 12-13 45-55 0,8-0,9 10-11 65-75 0,6-0,7 11-12 The pressure and temperature of the water, the variations of power supply and the quantity of dishes can change these values. Use of the appliance Refer to the following instructions for each step of pro- 5. -
Page 8: Use Of Dishwasher Salt
Water hardness Water hardness setting °dH °TH mmol/l Clarke manually electronically 29 - 36 51 - 64 5,1 - 6,4 36 - 45 23 - 28 40 - 50 4,0 - 5,0 28 - 35 19 - 22 33 - 39 3,3 - 3,9 23 - 27 15 - 18... -
Page 9: Use Of Rinse Aid
It is normal that water overflows from the salt container when you fill it with salt. Make sure that there is no grain of salt outer of the salt compartment. Salt which stays on the tank for a while drills the tank. It is recommended to start a washing programme immediately after you fill the salt container. -
Page 10: Load Cutlery And Dishes
Adjusting the dosage of rinse aid The rinse aid dial is set at the factory at position 4. To increase or decrease the dosage refer to 'What to do if...' Load cutlery and dishes Helpful hints and tips Caution! Only use the appliance for household utensils that are applicable for dishwashers. -
Page 11: Use Of Detergent
Maximum height of the dishes upper basket lower basket Lower position 24 cm 27 cm Do these steps to move the upper basket to the upper position: 1. Pull the basket out until it stops. 2. Carefully lift the two sides until the mechanism is engaged and the basket is stable. -
Page 12: Multitab Function
Fill the detergent dis- If you use a washing pro- gramme with prewash Different brands of detergent dissolve in different penser (A) with deter- times. Some detergent tablets do not have the gent. phase, put more deter- gent in the prewash de- best cleaning results during short washing pro- grammes. -
Page 13: Select And Start A Washing Programme
To use normal detergent again: 4. Do a washing programme without dishes. 1. Deactivate the multitab function. 5. Adjust the water softener to the water hardness in your area. 2. Fill the salt container and rinse aid dispenser. 6. Adjust the rinse aid dosage. 3. -
Page 14: Care And Cleaning
Let the dishes cool down before you remove them from Three minutes after the end of the programme, all in- the appliance. Hot dishes are easily damaged. dicator lights go off and the digital display shows one horizontal bar. Standby mode Press one of the buttons (not the on/off button), to go If you do not switch off the appliance at the end of the back to end-of-programme mode. -
Page 15: What To Do If
What to do if… The appliance does not start or stops during operation. yourself, contact your dealer or the Service Force Cen- If there is a fault, first try to find a solution to the problem tre. yourself. If you cannot find a solution to the problem Fault code and malfunction Possible cause and solution •... -
Page 16: Technical Data
The cleaning results are not satisfactory The dishes are not clean • The selected washing programme is not applicable for the type of load and soil. • The baskets are loaded incorrectly so that water cannot reach all surfaces. • Spray arms do not turn freely because of incorrect arrangement of the load. -
Page 17: Installation
Warning! To discard the appliance, follow the • Discard the door catch. This prevents the children procedure: to close themselves inside the appliance and en- danger their lives. • Pull the mains plug out of the socket. • Cut off the mains cable and mains plug and discard them. -
Page 18: Electrical Connection
Be careful when you connect the water inlet hose: • Do not put the water inlet hose or the safety valve in water. • If the water inlet hose or the safety valve is damaged, immediately disconnect the mains plug from the mains socket. - Page 20 www.electrolux.com 117957380-00-112008...