What To Do If - Zanussi ZDTS401 User Manual

What to do if...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
Fault code and malfunction
• intermittent audible signal
• digital display shows
The dishwasher does not fill with water
• intermittent audible signal
• digital display shows
The dishwasher will not drain
• intermittent audible signal
• digital display shows
The anti-flood device operates
The programme does not start
After the check, switch on the appliance. The pro-
gramme continues from the point of interruption. If the
malfunction shows again, contact your Service Force
Centre.
These data are necessary to help you quickly and cor-
rectly:
• Model (Mod.)
yourself, contact your dealer or the Service Force Cen-
tre.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The hose
can be kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The hose
can be kinked or squashed.
Make sure that the connection is correct.
• Close the water tap and contact your local Service Force Centre.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the programme immediately.
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
15