Care And Cleaning - Zanussi ZDTS401 User Manual

Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Standby mode
If you do not switch off the appliance at the end of the
washing programme, the appliance automatically goes
into standby mode. The standby mode decreases en-
ergy consumption.

Care and cleaning

Warning! Switch the appliance off before you
clean it.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
1
3
To remove filters B and
C, turn the handle ap-
proximately 1/4 anti-
clockwise.
14
2
Fully clean the filters A, B
and C below running wa-
ter.
4
Remove the flat filter A
from the bottom of the ap-
pliance.
Three minutes after the end of the programme, all in-
dicator lights go off and the digital display shows one
horizontal bar.
Press one of the buttons (not the on/off button), to go
back to end-of-programme mode.
5
Put the filter system in
position. To lock the filter
system, turn the handle
clockwise until it locks in
position.
Important! Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a cocktail stick.
External cleaning
Clean the external surfaces of the appliance and con-
trol panel with a damp soft cloth. Only use neutral de-
tergents. Do not use abrasive products, scouring pads
or solvents (acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is
not responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.