Installing Or Replacing The Optical Drive - Lenovo ThinkCentre M77 Hardware Maintenance Manual

7. Position the new memory module over the memory slot. Make sure that the notch
module aligns correctly with the slot key
down into the slot until the retaining clips close.
Figure 13. Installing a memory module
8. Reinstall the PCI Express x16 graphics card if you have removed it.
9. To complete the replacement, go to "Completing the parts replacement" on page 112.

Installing or replacing the optical drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://support.lenovo.com
This section provides instructions on how to install or replace the optical drive.
To install or replace an optical drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 79.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 80.
4. Depending on whether you are installing or replacing an optical drive, do one of the following:
• If you are installing a secondary optical drive, remove the plastic panel in the front bezel for the
drive bay you want to use. If there is a metal static shield installed in the drive bay, remove the
metal static shield.
86
ThinkCentre Hardware Maintenance Manual
2 on the system board. Push the memory module straight
1 on the memory