Completing The Parts Replacement - Lenovo ThinkCentre M77 Hardware Maintenance Manual

Hardware maintenance manual (hmm) - thinkcentre m77
Hide thumbs Also See for ThinkCentre M77:
Table of Contents

Advertisement

14. Install all memory modules and PCI cards removed from the failing system board on the new system
board. See "Installing or replacing a memory module" on page 125 and "Installing or replacing a PCI
card" on page 127.
15. Reconnect all remaining cables to the system board. See "Locating parts on the system board" on
page 119.
16. Lower the optical drive bay assembly. See "Accessing the system board components and drives" on
page 124.
17. Install the hard disk drive. See "Replacing the hard disk drive" on page 135.
18. To complete the replacement, go to "Completing the parts replacement" on page 160.
Note: If required, return the failing system board to Lenovo.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to close the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 "Using the Setup Utility program" on page 43.
To close the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating components" on page 118 for the locations of various
components in your computer.
2. If you have removed the front bezel, reinstall it. To reinstall the front bezel, align the three tabs on
the front bezel with the corresponding holes in the chassis and pivot the front bezel inwards until
it snaps into position.
3. Make sure that the cables are routed correctly. Keep cables clear of the hinges and sides of the
computer chassis to avoid interference with closing the computer cover.
4. Lower the optical drive bay.
5. Close the computer cover.
6. If there is an integrated cable lock available, lock the computer.
7. Reconnect the external cables and power cords to the computer. See "Locating connectors on the
rear of your computer" on page 117.
8. To update your configuration, see Chapter 6 "Using the Setup Utility program" on page 43.
Note: In most areas of the world, Lenovo requires the return of the defective Field Replaceable Units (FRUs).
Information about this will come with the new FRUs or will come a few days after you receive the new FRUs.
160
ThinkCentre Hardware Maintenance Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents