Replacing The Primary Hard Disk Drive - Lenovo ThinkCentre M77 Hardware Maintenance Manual

Hardware maintenance manual (hmm) - thinkcentre m77
Hide thumbs Also See for ThinkCentre M77:
Table of Contents

Advertisement

b. Note the orientation of the microprocessor in the socket. You can look for the small triangle
on one corner of the microprocessor. This is important when installing the new microprocessor
on the system board.
c. Touch only the edges of the microprocessor. Do not touch the gold contacts on the bottom.
d. Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must be
kept as clean as possible.
8. Make sure that the small handle is in the raised position.
9. Remove the protective cover that protects the gold contacts of the new microprocessor.
10. Hold the new microprocessor by its sides and align the small triangle on one corner of the new
microprocessor with the corresponding small triangle on one corner of the microprocessor socket.
11. Lower the new microprocessor straight down into the microprocessor socket on the system board.
12. Lower the small handle to secure the new microprocessor in the socket.
13. Reinstall the heat sink and fan assembly. See "Replacing the heat sink and fan assembly" on page 95.
14. Reconnect all cables that were disconnected from the system board.
15. To complete the replacement, go to "Completing the parts replacement" on page 112.

Replacing the primary hard disk drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://support.lenovo.com
This section provides instructions on how to replace the primary hard disk drive.
To replace the primary hard disk drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 79.
3. Locate the primary hard disk drive. See "Locating internal drives" on page 78.
4. Disconnect the signal cable and the power cable from the hard disk drive.
.
Chapter 8
Replacing FRUs (Machine Types: 1982, 1983, 1985, 1986, 1987, 1990, 1992, 1993, 1994, and 1995.)
1
99

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents