Replacing The Microprocessor - Lenovo ThinkCentre M77 Hardware Maintenance Manual

9. Position the new heat sink and fan assembly on the microprocessor socket and then position the
clamp on the plastic retention bracket. Pivot the handle
the plastic retention bracket.
Figure 29. Reinstalling the heat sink and fan assembly
10. Connect the heat sink and fan assembly cable to the microprocessor fan connector on the system
board. See "Locating parts on the system board" on page 77.
11. Reconnect any cables that have been removed.
12. To complete the replacement, go to "Completing the parts replacement" on page 112.

Replacing the microprocessor

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://support.lenovo.com
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
To replace the microprocessor, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 79.
3. Lay the computer on its side for easier access to the system board.
.
Chapter 8 Replacing FRUs (Machine Types: 1982, 1983, 1985, 1986, 1987, 1990, 1992, 1993, 1994, and 1995.)
1 to clamp the heat sink and fan assembly to
97