Table of Contents
Advertisement
RBSU configuration flow
RBSU configuration flow overview
RBSU can be used in two ways to configure a server: a manual flow and a scripted installation flow for
working with SmartStart software. Each method has its own flow of procedures. This information is of a
technical nature and intended for reference purposes only.
Manual path flow
NOTE:
Controller.
NOTE:
RBSU can be used to configure an HP server without the use of SmartStart. When the server is powered
up in an unconfigured state, RBSU executes when the F9 key is pressed, allowing the server to be
configured. After the server has been configured using RBSU:
Restart or power up the server.
1.
Press the F8 key to execute ORCA.
2.
After the primary array controller has been configured with ORCA, restart the server.
3.
Install the operating system
4.
applications as well.
Manual Path Flow does not apply for servers with an integrated ATA RAID IDE
Manual Path Flow is not necessary for servers with Embedded Server Setup.
("Operating System
Installation" on page 117). Install any necessary
RBSU configuration flow 124
Advertisement
Table of Contents
