Table of Contents
Advertisement
BIOS Serial Console design supports VT100+ protocol, and ANSI and V100 terminal emulation. VT100
is supported by all terminal emulation programs. However, ANSI supports enhanced graphics and is
more aesthetically appealing to some users. ANSI is the recommended choice if it meets the system
requirements. CLI support is available on some new servers for faster, more compatible display when
configuring a server using VT100 emulation. For more information, see "Command Line Interface
Overview (on page 119)."
When viewed in BIOS Serial Console, the RBSU main menu looks slightly different from the local server
view.
The following menu options are available:
•
BIOS Serial Console Port (on page 100)
•
BIOS Serial Console Baud Rate (on page 101)
•
EMS Console (on page 101)
•
BIOS Interface Mode (on page 102)
BIOS Serial Console Port
The BIOS Serial Console Port option provides additional selections for enabling BIOS Serial Console.
Selecting the Enable Remote option without the supported RILOE II or iLO firmware will result in an error:
The setting Enable Remote requires RILOE-II or iLO with firmware version
1.20 or greater (1.41 or greater with iLO firmware recommended). Do not
use the Enable Remote setting if iLO is Disabled and RILOE-II is not
installed.
RBSU menu (HP ProLiant G5 and earlier servers or server blades) 100
Advertisement
Table of Contents
