Rbsu Configuration Flow; Rbsu Configuration Flow Overview; Manual Path Flow - HP ProLiant xw25p User Manual
For use with hp proliant generation 5 servers
Hide thumbs
Also See for ProLiant xw25p:
- User manual (118 pages) ,
- Manual (10 pages) ,
- Troubleshooting manual (152 pages)
Table of Contents
Advertisement
RBSU configuration flow
In this section
RBSU configuration flow overview ............................................................................................................ 52
Manual path flow................................................................................................................................... 52
Scripted installation flow ......................................................................................................................... 53
RBSU configuration flow overview
RBSU can be used in two ways to configure a server: a manual flow and a scripted installation flow for
working with SmartStart software. Each method has its own flow of procedures. This information is of a
technical nature and intended for reference purposes only.
Manual path flow
NOTE: Manual Path Flow does not apply for servers with an integrated ATA RAID IDE Controller.
NOTE: Manual Path Flow is not necessary for servers with Embedded Server Setup.
RBSU can be used to configure an HP server without the use of SmartStart. When the server is powered
up in an unconfigured state, RBSU executes when the F9 key is pressed, allowing the server to be
configured. After the server has been configured using RBSU:
Restart or power up the server.
1.
Press the F8 key to execute ORCA.
2.
After the primary array controller has been configured with ORCA, restart the server.
3.
Install the operating system
4.
applications as well.
("Operating System
Installation" on page 46). Install any necessary
RBSU configuration flow 52
Advertisement
Table of Contents
