Connecting Speaker Cables - Yamaha RX-V673 Owner's Manual

1 2 3 4 5 6 7 8 9 10
Speaker connections
7.1-channel system
(using presence speakers)
The unit (rear)
SPEAKERS
FRONT CENTER SURROUND SURROUND BACK/BI AMP
SINGLE
SINGLE CENTER
FRONT SURROUND SUR. BACK 1 SUBWOOFER 2
AUDIO ZONE 2
PRE OUT
OUT OUT
Q
1 2
9 3
4
6.1-channel system
The unit (rear)
ZONE 2/PRESENCE FRONT CENTER
EXTRA SP
AUDIO ZONE 2
OUT OUT
W
1
9
5 4
When using only one surround back speaker, connect it
to the SINGLE jack (L side).
SPEAKERS
SURROUND SURROUND BACK/BI AMP ZONE 2/PRESENCE
SINGLE
EXTRA SP
SINGLE CENTER
FRONT SURROUND SUR. BACK 1 SUBWOOFER 2
PRE OUT
2
3
5
8
■

Connecting speaker cables

Speaker cables have two wires. One is for connecting
the negative (-) terminal of the unit and the speaker, and
the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive terminal.
a Remove approximately 10 mm (3/8") of insulation from
the ends of the speaker cable and twist the bare wires of
the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
d Tighten the terminal.
c
F R
+ (red) b
O N
T
a a
d
- (black)
Using a banana plug
(U.S.A., Canada, China, Australia and General models only)
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
a
F R
O N
T
Banana plug
b
PREPARATIONS ➤ Connecting speakers
20
En