Remote Control - Yamaha RX-V673 Owner's Manual

Problem
The files in the PC cannot be viewed or played
back.
The Internet radio cannot be played.

Remote control

Problem
The unit cannot be controlled using the remote
control.
External devices cannot be controlled using the
remote control.
The remote control does not learn new functions.
(RX-V773 [China, Korea, U.K. and Europe models]
only)
Cause
The files are not supported by the unit or the media server.
The selected Internet radio station is currently not available.
The selected Internet radio station is currently broadcasting
silence.
Access to the network is restricted by the firewall settings of your
network devices (such as the router).
Cause
The unit is out of the operating range.
The batteries are weak.
The unit's remote control sensor is exposed to direct sunlight or
strong lighting.
The remote control is set to control external devices.
The remote control IDs of the unit and the remote control are not
identical.
The remote control is set to control the unit.
The corresponding remote control code is not set properly.
The batteries of the remote control of the unit and/or the external
device are weak.
The distance between the two remote controls is not appropriate.
The signal coding or modulation of the other remote control is not
compatible with the remote control.
Memory capacity is full.
Remedy
Use the file format supported by both the unit and the media server. For
information about the file formats supported by the unit, see "Playing back music
stored on media servers (PCs/NAS)" (p.65).
There may be a network problem at the radio station, or the service may have
been stopped. Try the station later or select another station.
Some Internet radio stations broadcast silence at certain of times of the day. Try
the station later or select another station.
Check the firewall settings of your network devices. The Internet radio can be
played only when it passes through the port designated by each radio station.
The port number varies depending on the radio station.
Remedy
Use the remote control within the operating range (p.5).
Replace with new batteries.
Adjust the lighting angle, or reposition the unit.
Press RECEIVER to set the remote control to control the unit (the key lights up in
orange).
Change the remote control ID of the unit or the remote control (p.105).
Press SOURCE to set the remote control to control external devices (the key lights
up in green).
Set the remote control code again (p.108). Even if the remote control code is
registered properly, some products may not respond to the remote control.
Replace with new batteries.
Place the remote controls at a proper distance (p.110).
Learning is impossible in this case.
Clear unnecessary assignments to free some memory space for new functions
(p.111).
APPENDIX ➤ Troubleshooting
119
En