ViewSat VS2000 ULTRA User Manual page 11

You can see the progressive status of channel searching.
If you cannot find the desired transponder from the transponder list, you can add it by inputting
appropriate parameter values for a new transponder using the "F1" key. When you want to
change the parameter of an existent transponder, select the parameter using the "F1" key,
change its value and press the "Exit" key. Correctly set various parameters.
: Input the frequency of the transponder you want to find manually.
: Inputs the symbol rate of the transponder you want to find.
: Select the polarization of the transponder you want to find. In the case of
horizontal,18V and in the case vertical, 13V are output through LNB line.
: Select the FEC of the transponder you want to find. You can select the value of 1/2,
2/3, 3/4, 5/6, 7/8 or auto.
You can add a new satellite. Select the "Add Satellite" icon using the "left/right" keys (
and press the "OK" key.
Select the "Search/Edit TP" icon using the "left/right" key (
a new transponder using the "F1" key. You should set various parameters of the transponder.
The default name of the added satellites is "UserSAT-No."
You can also change the satellite name. Select the "Rename Satellite" icon using the "left/right"
keys ( ).
◀∙▶
Press "OK" key and select the character which you want to edit using the browse
keys ( ). Press the "OK" key to confirm. Save the character currently renamed using
▲∙▼,◀∙▶
the "F2" key.
You can also delete the user satellite. Select the satellite that you want to delete from the satellite list.
Select the "Delete Satellite" icon using the browse keys (
Press the "OK" key, and the selected satellite will disappear.
),
◀∙▶
). Press the "OK" key and add
◀∙▶
▲∙▼,◀∙▶ ).
Check the signal strength. Press "OK" key to
start the scan procedure.You can see the
progressive status of channel searching.
Please note that the scan procedure may take a
few minutes.
Press the "menu" key or "exit" key to return to
previous menu.
Blind Scan search the channel when you don't
know the transponder information.
Press the "OK" key to start the blind scan
procedure and the following screen will be
displayed.
Please note that the scan procedure may take a
few minutes.
Press the "menu" key or "exit" key to return to
previous menu.
This menu helps you to set up System. Select "User Setting" menu in "Main Menu", and
you will be asked to enter your PIN Code.