Table of Contents
Advertisement
3.3 Advanced Menu
This section facilitates configuring advanced BIOS options for your system.
Main
Installed O/S:
Reset Configuration Data:
Large Disk Access Mode:
Advanced Chipset Control
Advanced Processor Options
I/O Device Configuration
Hardware Monitor
DMI Event Logging
Legacy USB Support:
Console Redirection
F1
Help
¡ ô ¡ õ
Esc
Exit
¡ ö
¡ ÷
Installed OS
Select the operating system installed on the PC.
NOTE: An incorrect setting can cause the operating system to display
unexpected behavior.
Win2K/XP / Other
Reset Configuration Data
If you install a new piece of hardware or modify your computer's hardware
configuration, the BIOS will automatically detect the changes and reconfigure
the ESCD (Extended SystemConfiguration Data). Therefore, there is usually no
need to manually force the BIOS to reconfigure the ESCD.
However, sometimes, the BIOS may not be able to detect the hardware
changes. A serious resource conflict may occur and the operating system may
not even boot as a result. This is where the Reset Configuration Data BIOS
feature comes in.
This BIOS feature allows you to manually force the BIOS to clear the previously
saved ESCD data and reconfigure the settings. All you need to do is enable this
BIOS feature and then reboot your computer. The new ESCD should resolve
the conflict and allow the operating system to load normally.
PhoenixBIOS Setup Utility
Advanced
Security
Select Item
-/+
Select Menu
Enter
Power
[Win2K/XP]
[No]
[Enabled]
Change Values
Select
Sub-Menu
38
Boot
Exit
Item Specific Help
F9
Setup Defaults
F10
Save and Exit
Advertisement
Table of Contents
