For Analog Cable And Antenna Users; Devices) - Sceptre X20 Getting Started Manual

For Analog Cable and Antenna Users

Note: The following instruction set is for TV tuner antenna, analog cable users only.
When using the TV for the first time, you must perform the channel scan to get all
correct channels by doing the following: Press the "SOURCE" button on the
remote controller to select the TV input signal labeled either "Cable ###" or "Air
###". # represents numbers.
1. Press MENU button to activate the On Screen Display (OSD) menu
2. Press "VOL -/+" (
3. Press "CH -/+" (
4. Press "CH -/+" (
" "(button in the center of VOL -/+ & CH -/+).
5. Press "VOL -/+" (
For Set-top Box Users (including Digital Cable, Satellite, other video
displaying devices)
Note: The following instruction set is for set-top box users (including digital cable,
satellite box, and other video devices)
1. Make sure your video cables are connected correctly to the back of the television
color matching all ports.
2. Press the "SOURCE" button on the remote controller to select the TV input signal
which you've connected the set-top box to TV, AV, HDMI, HDCP, DVI, VGA-PC,
VGA-YPbPr2, or YPbPr1(Component).
3. Please consult your set-top box's manual with regards on how to turn on the
device and browse channels.
Page28
)button to select the "TV SETUP" function group
)button to select correct "Cable/Air" signal source
)button to select "CH-SCAN" function and then press
)button to start scanning the available channels.
SCEPTRE X20