Basic Side Burner Operation - Cal Flame BBQ08852P Owner's Manual

14
Manually Lighting the Side Burners
WARNING: Do not use standard matches or cigarette lighters to per-
form match lighting procedures. Serious burns can occur and lighters
can explode.
1. Open the hood.
2. If you have just attempted to light the burner, allow five minutes
for any accumulated gas to dissipate.
3. Keep your face as far away from the burners as possible.
4. Light and insert a long stem match, holding it near the burner
ports.
5. Push in and turn the control knob just past the LIGHT position to
HIGH.
6. Listen for the sound of the gas igniting. If the burner does not
light after five seconds, turn the control knobs to the OFF position.
Wait five minutes until the gas clears before attempting to light it
again.
7. If the burner does not light after several attempts see Trouble-
shooting Guide in the back of this manual.

Basic Side Burner Operation

Before lighting, make sure all burner controls are off. Do not attempt
to light the burners if the smell of gas is present. Check the connection
with a soap and water solution after attaching the hose. For LP units,
make sure there is gas in the tank and it is sitting upright. For natural
gas units, make sure the shut off valve is on.
1. Light the side burners using the instructions on the previous
page.
2. Place pots on the side burners and cook to desired completion.
Adjust heat setting if necessary. You may set the control knob to
any position between HIGH and LOW.
Do not leave the side burner unattended while cooking.
www.calspas.com
Cal Flame Side Burners
LTR50001082, Rev. B