Table of Contents
Advertisement
6. Re-install the ISS in its previous location.
7. Open the SIM cover and connect the WIND (anemometer) cable.
8. Plug in the solar panel cable to the solar panel connector.
9.
Cabled ISS Only:
10. Re-insert the foam into the cable access port in the SIM box.
11. Close the SIM box.
12. Use cable ties to secure cables.
Take the Console Out of Setup Mode
1. At your Vantage Pro2 console, press and hold DONE for three seconds to
take the console out of Setup Mode.
2. Check the console for erroneous rain data and clear if necessary.
To clear erroneous daily rain data:
•
Select the RAINDAY button. The graph icon displays next to the daily
rain variable.
•
Press and release 2ND, then immediately press and hold CLEAR.
•
The daily rain variable will start blinking.
•
Keep holding CLEAR until the reading changes to zero.
•
Refer to your Vantage Pro2 Console Manual for more information on
clearing any other weather variables or clearing all weather variables in
the console.
You have completed the replacement kit.
Connect the console cable.
7
Advertisement
Table of Contents
Need help?
Do you have a question about the Temperature/Humidity Sensor Replacement Kit and is the answer not in the manual?