Table of Contents
Advertisement
Powering the Fan
The Cabled ISS fan is powered by an AC-power adapter. The Wireless ISS fan is
solar-powered and uses batteries for overnight power storage.
Solar Power Connector
(Wireless ISS Only)
AC Power Adapter Connector
(Cabled ISS Only)
Connecting AC Power (Cabled ISS)
1.
Locate the Junction Board on the fan plate (See below).
2.
Connect the AC-power adapter to the +5V connector on the Junction
Board.
3.
Plug the AC-power adapter into an AC outlet.
4.
Check to see that the fan is blowing air in the upward direction.
Unplug the AC power adapter from the AC outlet until you are ready to
5.
mount the ISS.
6.
Secure the AC power cable and sensor cable to the fan plate with the sup-
plied cable clip.
#4 x 1/2" Screw
#4 Flat Washer
Cable Clamp
Sensor Cable
AC-Power Adapter
Preparing the ISS for Installation
Cable
AC Power-Adapter Cable Routing
SIM Power Cable
(Wireless ISS Only)
MOTOR
+VSOL
+5V
Junction Board Connections
Fan Connector
Fan Plate
Battery
Compartments
(not used in
AC Models)
Fan Motor
Junction
Board
Page 7
Advertisement
Table of Contents
