Making The Chain Play List - Fostex VF160 Supplement Owner's Manual

VF160 Owner's Manual <V2.0 Supplement>

Making the chain play list

Before executing chain play, you must make the chain play list by selecting the desired
(or all) programs in the desired order. You can enter up to 99 programs to the chain
play list.
On pages 7 and 8, two procedure examples for entering programs on the VF160
current drive to the list are shown. The former example shows how to enter all
programs on the current drive, while the latter shows how to enter desired programs.
Both examples assume that 10 programs exist on the current drive.
1)
2)
3)
While the VF160 is stopped, press the [SETUP] key.
The VF160 enters the setup mode and the display changes to show the "Select Menu"
screen for selecting a setup menu item.
By default, the "Signature Set" flashes as shown in the figure below.
flashing
Use the [JOG] dial to select "Chain Play List" which is the 23rd menu item (R23) in
the setup menu, and then press the [ENTER/YES] key.
The display changes to show the "Chain Play List" screen, in which "C01:END" is highlighted
by default. "C01" shows the step number, while "END" shows no program is entered to the
chain play list.
flashing
Press the [ENTER/YES] key again.
"END" starts flashing and you can now enter a desired program to step 01.
By rotating the [JOG] dial while "END" is flashing, you can select a desired option from
among the programs on the drive ("P01" through "P10"), as well as "ALL", "INS" and "DEL".
See the table below for details about each option.
The current and succeeding steps in the chain play list are all deleted. (See "Deleting
END
all programs from the chain play list" described later for details.)
All programs on the current drive are entered to the chain play list. Note that you
ALL
can select "ALL" to step 1 (C01) only. There is no "ALL" option on other steps. (See
"Making the chain play list by selecting all the programs" described later for details.)
A desired program can be added (inserted) to the current step. (See "Inserting a
INS
program to the chain play list" described later for details.)
The program on the current step is deleted. (See "Deleting a program from the
DEL
chain play list" described later for details.)
A desired program is entered to the current step. If another program is already
P01
entered, the new program overwrites it. You can select any of the programs on the
-
current drive. (See "Making the chain play list by selecting desired programs"
Pnn
described later for details.)
6
flashing