Table of Contents
Advertisement
Optional Programmer
2.6
Optional Programmer
The optional Fire-Watch 411 Series DACT Programmer is used to:
switch between the digital communicator's five Modes of operation
set the digital communicator's 24 hour internal clock in Real-Time Clock Mode
program the 411 digital communicator in Program Mode
test the telephone lines interconnect in Troubleshoot Mode
return all digital communicator programming to the factory default settings in Default Mode
To use the 411 Series DACT Programmer:
Remove all power from the 411
1.
Remove the two screws holding the 411 cover in place and remove the cover
2.
Connect the Programmer cable to connector J2 located in the upper right corner of the 411. Note that the key
3.
on the connector must align with the slot in the J2 connector
Reapply power to the 411
4.
Operate the Programmer by pressing the MODE key. Enter the appropriate four digit Mode code and then
5.
press the [ENTER/STORE] key.
Note that it is not possible to switch from Normal Mode to any other mode if any of the four Channels is programmed
for fire alarm or fire supervisory, and is active, that is, in alarm (shorted).
Programmer Connection to 411
FIGURE 2-5:
411
411 Communicator
Cable attached to Programmer
J1
TB2
U10
U8
R41
TB1
J4
Document #50921
Rev. E
8888
LAMP
TEST
Programmer
1
2
3
4
5
6
7
8
9
A
0
B
J2 connector
J2
PH1
PH2
12/09/2008
P/N 50921:E
MODE
F
E
1ST
D
EVENT
ENTER
C
STORE
19
Hide quick links:
Advertisement
Table of Contents
